300 A current clamp

AC current waveforms. Wireless bridge connection.

See how your motor draws current

Capture current waveforms on motors, pumps and other electrical equipment. Fit the clamp around one conductor and connect it to the Current Clamp AD Module for recording and spectrum analysis on the M4.

Current range: 0.1–300 A RMS · 50/60 Hz
Clamp opening: 24 mm diameter
Connection: Shielded cable to the acquisition module

Compare models Technical details

Match the clamp to the conductor

Choose by current range, conductor diameter and voltage rating. Each clamp measures one conductor.

100 AView model

Current: 0.1–100 A RMS
Opening: Ø 16 mm
AC model: 300 V

300 AThis model

Current: 0.1–300 A RMS
Opening: Ø 24 mm
AC model: 300 V

600 AView model

Current: 1–600 A RMS
Opening: Ø 36 mm
AC model: 600 V

Range ratings at 50/60 Hz. The AD module records the waveform for time and frequency analysis.

Explore current spectrum analysis

Connect through the Wireless Sensor Bridge

The sensor connects by cable to its AD module inside the bridge. The bridge transfers recorded measurements to an M4 with a compatible iQunet radio interface.

Bridge, power & cable options

Edge Gateway M4 Local storage & analysisExplore the gateway

Technical details

Measurement specs

Product documents

Datasheet

System components

Current clamp AD module Wireless Sensor Bridge

Request a quotation

300 A current clamp

A 300 A clamp with a 24 mm opening. Add the matching cable, AD module and bridge to suit your setup.

Measurement specifications

ICUR273010-CLAMP-300A details

Current: 0.1–300 A RMS at 50/60 Hz. 300 V AC model; use its documented electrical installation limits.
Clamp opening: 24 mm internal diameter; clamp around one conductor.
Signal: Integrated amplifier and open-circuit protection. Match the clamp sensitivity in the acquisition settings.
Environment: −20°C to +60°C. No specified ingress-protection rating; install in a suitable enclosure or protected location.

Connection & mounting

Clamp, AD module and Wireless Sensor Bridge

One current clamp connects by cable to its matching AD module in the bridge. The bridge sends digitized measurements through the iQunet wireless network to the edge server. Match the clamp, module and cable before installation.

Clamp around one conductor and connect to a matching Current Clamp AD Module using its shielded cable. The clamp, module, cable and bridge are selected separately.

Compatible components

Datasheets & installation

300 A current clamp datasheetCurrent Clamp AD Module datasheet