Shop

100A Current Clamp

269,52

SKU: ICUR271010-CLAMP-100A Category: Tag:
Share:
Synopsis

The iQunet 100A Current Clamp is a compact clamp-on sensor that monitors current consumption on existing power equipment. The clamp can for example easily be clicked over one of the power lines of a 3 phase motor or other electrical appliances.

Description

Description

Industrial 100A Current Clamp

The iQunet 300V~ 100A Current Clamp is a high-frequency sensor that monitors asset health of power equipment which fits well in the predictive maintenance and asset reliability strategy.

 

The iQunet 100A Current Clamp is a compact clamp-on sensor that monitors current consumption on existing power equipment. The clamp can for example easily be clicked over one of the power lines of a 3 phase motor. The sensor is equipped with a built-in open-circuit protective device. It captures the analog current time series which is automatically amplified by the integrated 22.6 mV/A amplifier. The Current Clamp sensor can be integrated in the iQunet system via the iQunet Current Clamp module installed in the iQunet Wireless Sensor Bridge where the analog signal is digitalized and prepared for wireless transfer to the iQunet Server. The digital sensor data can then be collected on the iQunet Server and sensor parameters such as sampling rate, number of samples, automatic measurement interval, etc. can be set remotely. The sensor also receives its power from the Wireless Bridge over the shielded cable so there is no need for an external power source.

 

The sensor makes a network connection to the central Base Station node via the Repeater module build in to the Wireless Bridge. Sensor data is visualized in the iQunet Sensor Dashboard on the iQunet Data Server, offering time series in current (A) and charge (A.s), spectrum graphs in (A),  and (A.s) including waterfall plots, RMS trend values and graphs in (A), and (A.s), peak values, etc.

 

Used in: current waveform monitoring in industrial environments, for easy installation on existing power equipment

 

Technical specifications:

  • Physical: 
    • Dimensions (mm): 32.5 x 47.5 x 35
    • Internal clamp diameter (mm): 16
    • Weight: 71g
    • Output connector: Molex Ditto
    • Output lead wire length: 130 mm

  • Installation: clamp-on
  • Operating temperature: -20° to +60°C
  • Storage temperature: -30° to +60°C
  • Compliance: 
    • RoHS: 2002/95/EC
    • 24V IEPE compatible
  • Electrical characteristics: 
    • Applicable current (50/60Hz): AC 0.1 to 100 Arms
    • Maximum allowed current: AC 200 Arms continuous
    • Withstanding voltage (1 min.): 2.2kVAC
    • Measurement axis: 1 axis
    • Integrated amplifier: 22.6 mV/A
    • Open-circuit protection: 7.5V clamp element
    • Units: A   
  • Temperature sensor on board: no
  • Data storage: on iQunet Data Server (via the iQunet Current Clamp module for the Wireless Bridge)
  • Documents

    100A Current Clamp Datasheet

    Download(859 KB)